The is a versatile digital battery charging and discharging controller module designed to manage battery health by preventing overcharging and over-discharging . It is commonly used in DIY electronics, solar power setups, and battery maintenance systems. Core Functionality
In this mode, the module connects the charger to the battery when the voltage drops below a set lower limit () and disconnects it when the battery reaches the upper limit ( UP ). Condition to Start: Voltage ≤is less than or equal to dn . Condition to Stop: Voltage ≥is greater than or equal to UP . 2. Discharging Mode (dn) xycd60 manual
This mode is used to protect batteries from deep discharge. The module connects the load when the battery is full and disconnects it once the voltage hits a minimum threshold. Voltage ≥is greater than or equal to UP . Condition to Stop: Voltage ≤is less than or equal to dn . Setting Up the XY-CD60 Entering Setup The is a versatile digital battery charging and
Percentage=Current Voltage−dnUP−dn×100%Percentage equals the fraction with numerator Current Voltage minus dn and denominator UP minus dn end-fraction cross 100 % Condition to Start: Voltage ≤is less than or equal to dn
High-definition LCD screen showing voltage, percentage, and time. Modes: Charging Mode ( UP ) and Discharging Mode ( dn ). Operating Modes Explained 1. Charging Mode (UP)
The module supports TTL level UART communication (baud rate 9600), allowing you to read voltage and status or change settings via a computer or microcontroller.