Xh-m608 Manual ✯ ❲FREE❳

Set a value from (minutes) to enable a timed charge or discharge session. 4. Advanced Functions & Troubleshooting ainow.inhttps://ainow.in XH M608 Battery Charge And Discharge Module - AINOW

The relay does not function; it only displays the current voltage.

Relay closes when voltage ≤ P1 (lower limit) and opens when voltage ≥ P2 (upper limit). Xh-m608 Manual

Relay closes when voltage ≥ P2 (upper limit) and opens when voltage ≤ P1 (lower limit). Setting the Limits (P1 & P2)

When the battery is low, the relay closes to allow the charger to work. When full, it opens to prevent overcharging. Set a value from (minutes) to enable a

Sets the trigger for starting a charge or stopping a discharge.

For a 12V battery, you might set P1 to 10.8V and P2 to 14.4V to automate the charging cycle. P3: Timer Function Set this to 0 to disable the timer. Relay closes when voltage ≤ P1 (lower limit)

The module uses a menu system (P0 to P3) to define its behavior. Use the button to navigate and the + / – buttons to adjust values. P0: Operating Mode Selection