Ts1162 Installation Manual Exclusive Link

: Fully protected against dust and immersion in water, making it suitable for wet or outdoor environments.

: Use appropriate screws or bolts for the surface material (e.g., masonry anchors for brick or self-tapping screws for metal). Tighten firmly but avoid over-tightening, which can warp the plastic housing. Step 3: Wiring and Connections

: Use the DIP switches or software configuration (depending on your specific panel version) to assign a unique address to the RAS. ts1162 installation manual exclusive

: Verify the 3-LED status indicators correctly reflect the arming state of the assigned areas. Test the RTE input and the door strike output to ensure full functionality. Maintenance and Replacement

Once hardware is installed, the RAS must be identified by the Challenger panel. : Fully protected against dust and immersion in

: If using an exit button, connect it to the Request to Exit input.

: Select a flat, solid, vertical surface. Mounting on uneven surfaces can cause the base to flex, potentially compromising the IP67 seal. Step 3: Wiring and Connections : Use the

: Connects via the Challenger RS-485 LAN , supporting distances up to 1.5 km from the main controller.

: Use high-quality twisted-pair cable for the RS-485 connection to ensure signal integrity over long distances (up to 1.5 km). Step 2: Mounting the Unit