Ts1162 Installation Manual Extra Quality | 720p 2025 |

Use the base as a template to mark screw holes. Use appropriate fasteners for the mounting surface (e.g., wall plugs for masonry). 2. Wiring and Terminals

This guide outlines the physical installation, wiring, and addressing procedures for the TS1162.

The TS1162 is designed for surface mounting. Its durable plastic housing allows it to be placed up to 1.5 km away from a Challenger panel or Intelligent Access Controller via the RS-485 LAN. ts1162 installation manual

For further technical support or to download the full PDF documentation, visit the Aritech Support Portal or Ness Corporation .

Test the keypad by entering a valid user code to arm/disarm the assigned areas. Use the base as a template to mark screw holes

12V DC power from the Challenger LAN or an external power supply.

Ensure the mounting surface allows the rear tamper lever to be fully depressed when the unit is secured. Enclosure Removal: Undo the retaining screws at the bottom of the keypad. Wiring and Terminals This guide outlines the physical

All power should be disconnected from the Challenger panel before wiring the RAS. The TS1162 typically features a pre-wired tail or screw terminals for the following connections: Connection Description

Choose a flat, solid, vertical surface to prevent the base from warping when tightened.

If the device is more than 100 meters from the main panel, it is recommended to use an external 12V power supply while maintaining a common negative (–) reference with the LAN. 3. Configuration (Addressing & Termination)