Kes Geyser Load Control Timer Manual New __hot__ (Must Try)
Most KES models block overrides during peak demand times (typically 06:00–08:00 and 18:00–20:00) to comply with load-balancing standards. Installation & Setup Instructions
Optimized for solar setups. OFF from 08h00 to 15h00 and during all peak demand times. Prog 3 3 flashes / second
The override typically lasts for one hour (or until the next programmed event). kes geyser load control timer manual new
The unit can be mounted on a DIN Rail inside your DB or a surface-mounted enclosure. Wiring: Connect the Live (L) input from the geyser circuit breaker. Connect the Neutral (N) wire from the DB's neutral bar.
On some versions, you can verify the Real Time Clock (RTC) by holding the Override and Program buttons together. Most KES models block overrides during peak demand
The device features three primary LED status indicators and four preset profiles: Indicates the mains power is ON. Red LED: Indicates the geyser itself is ON and heating.
The KES ISG1201 includes four factory-set profiles. To select a program, use the button to cycle through them. Blue LED Pattern Function & Operating Hours Prog 1 1 flash / second Prog 3 3 flashes / second The override
Always ON, but automatically locks out during morning and evening peak hours (Monday–Friday). Prog 2 2 flashes / second
ON for only 6 hours on weekdays and 12 hours on weekends. Highly restrictive to minimize costs. Manual Controls & Override
Press the Override button to switch the geyser ON immediately.
