Sometimes the error is transient. Turn the truck off and on again to see if the self-test clears the fault.
Ensure the tiller handle and all control buttons (butterfly switches) move freely and are not physically stuck or gritty. jungheinrich eje 120 error code 4372 top
In cases of severe internal damage or unresolvable wiring issues, the entire tiller head assembly may be replaced. Summary Table: Jungheinrich 4372 Potential Issue Tiller Head Sensor signal out of range Recalibrate using Judit Software . Firmware Neutral zone too narrow Update firmware to expand the neutral "window". Wiring Broken or pinched wires Inspect tiller arm harness for continuity. Sensors Physical failure Replace traction or steering sensors. Sometimes the error is transient
The internal sensor card or the traction sensor may need replacement. In cases of severe internal damage or unresolvable
Inspect the wiring harness that runs through the tiller arm. This area is subject to constant flexing and is a common point for wire fatigue or shorts. 2. Software Calibration (Requires Judit Diagnostic Tool)
The controller detects that there is no neutral zone (zero-travel position) for the drive or lift/lower functions. This can be caused by physical wear, electrical drift, or outdated firmware that has a "neutral window" that is too narrow to accommodate normal sensor aging. Secondary Causes: Faulty traction or steering sensors within the tiller head. Damaged or loose wiring in the tiller head harness.