Jby6201 Manual «GENUINE ✮»

Keep the gun 10–12 inches from the surface. Move your arm before pulling the trigger, and release the trigger before stopping your movement to avoid "piling" paint. 4. Safety Precautions Warning: High-pressure injection hazard.

Before pulling the trigger, it is vital to know the limits of your hardware: Typically 1100W – 1500W (model dependent). Max Pressure: 3300 PSI (22.7 MPa). Flow Rate: Approximately 2.0 to 2.5 Liters per minute. jby6201 manual

Usually supports up to a 0.017" or 0.019" tip. 2. Initial Setup & Priming Keep the gun 10–12 inches from the surface

Before cleaning or servicing, turn off the power, switch to PRIME mode, and pull the gun trigger to bleed off any remaining internal pressure. Safety Precautions Warning: High-pressure injection hazard

Increase pressure slightly until fluid flows steadily out of the return tube. This clears the pump. 3. Operation: Switching to Spray Mode