: If you must change thickness, use a ramp to transition between the two areas.
: Instead of one solid chunk of plastic, "core out" the area to create a hollowed-out shape supported by ribs. injection molding part design for dummiespdf exclusive
Designing for injection molding can feel like a high-stakes puzzle, but once you master a few fundamental rules, you can create parts that are both functional and cost-effective. Whether you are a hobbyist or an engineer in training, this guide breaks down the "holy trinity" of injection molding: , Draft , and Material Selection . 1. The Golden Rule: Uniform Wall Thickness : If you must change thickness, use a
: As a rule of thumb, ribs and bosses (the posts used for screws) should be about 40% to 60% of the thickness of the main wall to prevent "sink marks" (dimples on the surface). 2. Let it Go: Draft Angles A Beginner's Guide to Injection Molding - Protolabs Whether you are a hobbyist or an engineer
The single most important principle in injection molding design is maintaining uniform wall thickness. When plastic cools, it shrinks; if one area of your part is significantly thicker than another, it will cool at a different rate, leading to internal stress.