Bg2-u01 Test Point: Huawei

To access the test point, you must carefully remove the back cover of the tablet. Use a plastic prying tool to avoid damaging the internal components or the battery. 📍 The Physical Location Look at the motherboard near the . Locate the small gold-plated circular contacts (pins).

Ground yourself before touching the motherboard to prevent ESD damage.

Under "Ports (COM & LPT)," you should see . Once recognized, you can release the tweezers. 4. Flashing or Unlocking Open your software of choice. Load the correct scatter file or firmware. Execute the "Flash" or "Reset FRP" command. Important Safety Tips huawei bg2-u01 test point

Before starting, ensure you have a high-quality micro-USB cable and the necessary MTK drivers installed on your PC. 1. Preparation Install the .

While holding the tweezers in place, plug the USB cable into the tablet. Check your PC's . To access the test point, you must carefully

A test point is a physical contact on the device's motherboard. By shorting this point to the ground (the metal shielding) while connecting it to a computer, you force the tablet into .

Ensure the tweezers are making solid contact with both the pin and the ground shield simultaneously. Locate the small gold-plated circular contacts (pins)

Power off the tablet and disconnect the battery cable from the motherboard. 2. Shorting the Pins Use a pair of metal tweezers. Place one tip on the . Place the other tip on the metal shield (GND). 3. Connection

The specific test point for the BG2-U01 is typically located , near the top edge of the board.