Install Exclusive: Http V515

Follow the on-screen instructions in the portal to scan for and select your home's 2.4 GHz Wi-Fi network. Enter your network password when prompted. The camera's LED will turn once it has successfully connected to the internet. 5. Add the Camera to Your Alarm.com Account

Plug the AC power adapter into the camera and a non-switched outlet. Wait approximately 2–3 minutes for the camera to boot. The status LED should begin to , indicating it is ready for Wi-Fi configuration.

Troubleshooting : If the LED is not blinking white after two minutes, hold the for about 6 seconds until it begins to blink. 2. Connect to the Camera's Temporary Wi-Fi http v515 install

: Perform the setup near the camera's final location to ensure a strong Wi-Fi signal. Step-by-Step Installation Guide via http://v515install 1. Power On the Camera

Before starting the installation process, ensure you have the following ready: : Your camera and its included AC power adapter. Follow the on-screen instructions in the portal to

. This address allows users to connect their camera to a local 2.4 GHz Wi-Fi network when using Access Point (AP) mode. Pre-Installation Checklist

The "http://v515install" URL is a critical web-based interface used to set up the Alarm.com ADC-V515 1080p Indoor Wi-Fi Camera Go to product viewer dialog for this item. The status LED should begin to , indicating

Using a smartphone or computer, search for available Wi-Fi networks. Connect to the network named , where "XX" represents the last six characters of the camera's MAC address. 3. Access the Configuration Portal

With the camera online (solid green LED), you must link it to your security account: 1080p Indoor Wi-Fi Camera Installation Guide - Surety

: A 2.4 GHz Wi-Fi connection. Note that the does not support 5 GHz networks.