: Reconnect the power. The Liso will automatically detect the USB drive and display a 30-second countdown before starting the flash.
: Unplug the USB drive and restart the unit. It should now boot into the initial configuration screen. 3. Alternative: Administration Panel Reset
This process will erase all configuration, unpair the device from Evoko Home , and revert the firmware to the version on the USB. evoko liso factory reset verified
To perform a on an Evoko Liso room manager , you must use a bootable USB flash drive containing the official firmware reset image . Unlike many consumer devices, the Evoko Liso does not have a simple "factory reset" button; the pinhole on the bottom of the unit is for rebooting only and will not wipe data or configuration settings. 1. Prepare the Reset USB Drive
Select and enter your PIN or use an authorized RFID. : Reconnect the power
Ignore any Windows prompts to "format the drive" after flashing; these occur because the Liso uses a non-Windows partition. 2. Execute the Factory Reset
: Wait for the message: "Flash has been successfully completed!" . It should now boot into the initial configuration screen
: Plug the prepared reset drive into the USB port on the back/bottom of the unit.
: Disconnect the PoE or power cable from the back of the Liso.
Insert a USB drive (at least 4GB; note that Kingston drives are often incompatible with Liso). Select the downloaded .gz image and flash it to the drive.