Decastar 150e Manual Top !new! Info

Close the pressure counter-roller. Adjust the pressure to an intermediate value—too much can crush the wire, while too little causes slipping.

For Gasless (Flux-cored) welding, you must reverse the polarity (check the internal terminals near the wire drive). Quick Settings Reference for Common Materials decastar 150e manual top

Independent of power settings, allowing you to shut down without losing your previous voltage adjustment. Operating Instructions: Setup and Wire Installation Close the pressure counter-roller

Remove the gas nozzle and contact tube from the torch head before feeding the wire through to the tip. decastar 150e manual top

Cut off the bent end of the wire cleanly. Feed it into the wire feed input (approximately 50–100 mm) towards the torch neck.