Permanently attach the disengaging label near the manual disengagement knobs. 3. Control Box (ECS 950) Setup
Fit the first stop ring onto the pivot/shaft, then slide the adapter onto the pivot.
Connect the operator cables to the Manoeuvring Card inside the control box. Ensure the C-card (main logic) is seated correctly in the lid. Initial Startup: Disconnect power before making any wire changes. Position the door manually about above the ground. Set the SW1 (Installation Switch) to ON . crawford cdm9 950 installation manual top
Adjust the unit’s position to ensure it is level and tighten all screws securely.
Always check that the side door switches and spring brake sensor are not sending false "STOP" signals before assuming an electrical fault. Permanently attach the disengaging label near the manual
The control box manages the door's logic and safety features.
If major electronic failure occurs (e.g., faulty processor card), official guidelines recommend replacing the complete operator to meet current safety standards. Connect the operator cables to the Manoeuvring Card
Are you currently seeing a specific on your ECS 950 display?