Astm A786 Pdf __link__ -

ASTM A786 recognizes several standard patterns (Designations 1, 2, 3, etc.), though individual manufacturers may have proprietary variations that closely resemble these. Minimum Pattern Height: For base material ≥is greater than or equal to 0.070 in, the minimum lug height is 0.020 in (0.5 mm). Standard Weight and Thickness Table

The raised figures (lugs) on the plate are produced during the final pass of the hot-rolling process.

While ASTM A786 defines the "pattern" and "dimensions," the actual steel grade must be specified by the purchaser from a list of approved ASTM designations. astm a786 pdf

A786 Floor Plate - Structural Steel Plate - Kloeckner Metals

Sheet, heavy thickness sheet coil, or plate. While ASTM A786 defines the "pattern" and "dimensions,"

For a standard low-carbon A786 plate, typical mechanical properties include a tensile strength of approximately 60,000 psi (414 MPa) and a yield strength of 33,000 psi (207 MPa).

It is considered easily weldable, though thicker plates (above 3/4 inch) may require preheating due to carbon content limits (typically capped at 0.25% or 0.33% depending on grade) to prevent cracking. Pattern and Designations It is considered easily weldable, though thicker plates

The standard is published in both inch-pound and SI (metric) units, which must be used independently. Material Properties and Grade

Common pairings include ASTM A36 for general structural use, A572 for high strength, or A514 for quenched and tempered applications.

A786 floor plates are often estimated using theoretical weights based on a steel density of 490